My Raspberry Pi got a make over today. I had previously installed a fan on it due to overheating issues but recently it started making a lot of noise.
On inspection, the bearing was worn, causing a wobble, and the blades were tapping the casing.
I went to Adafruit to order a new fan, but with shipping, it was more than I wanted to pay.
Amazon showed me a kit with a case, that included a fan and 3 heat sinks. It was about $0.40 more expensive than just ordering the fan. This is the one I ended up ordering.
It arrived this afternoon, and I set to putting the case together and getting everything hooked up.
Unfortunately, while it came with plenty of hardware, the screws to mount the board to the base were way too short, but this was easily remedied by using the screws that came with my now broken fan.
But it went together in the end, I got everything hooked back up, and it looks pretty damn good! I do miss my bright pink case but I think this will keep my Pi a lot cooler.
Edit : uncooled Pi 3 was operating at about 175°F. Fan cooled Pi 3 in closed case was holding at about 140°F. Fan, 3 heat sinks and open case Pi 3 is operating at about 100°F. Big improvement!